Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am dealing with a SIP trunk installation in India (provider Tata).
The provider has registration & authentication as a requisite and now they are requesting us to change all our sip traffic in order to communicate with them with source port a...
Hi, I am testing the following setup: CUCM -- SIP trunk -- ISR 4331 -- PRI Like I said this is a test environment so the PRI are not yet plugged in the NIM E1 cards. So the inbound/outbound dial-peers tied to the PSTN are down by now. So Im testing...
Hi, Im just trying to set up a brand new UCS-C220-M5 and having serious difficulties, After configuring the CIMC addressing, I found out that the hard drives (6 x SAS SFF HDD) are not being detected. I need to get to the Hypervisor configuration util...
Hi, I have the following setupCUCM PUB + SUB System version: 11.5.1.15900-18 Everytime a backup is attempted (no matter if its scheduled or manual), when all components are backed up and each one of them show "100% SUCCESS", the process get stuck in ...
Hi,Im setting an ISR4K (4331) with IOS XE Fuji for voice functionality connected to a providers on-premise router for SIP trunking and voice functionality.The specs datasheet from the provider states that for the voice functionality to work over thei...
Thanks again @b.winter
the command "source-port" might be what Im looking for in order to change UDP to 5061 as a source port in my SIP requests.
However I tried to look for this command under voice service voip level, sip level, sip-ua level and d...
Hi, thanks for your reply !!
Indeed the suggestion you posted did work for destination port without an IOS upgrade, thanks for the tip
my main issue here is now in doing the same thing for source port 5061, I still need this to be accomplished ...
thank you both @Roger Kallberg and @Maren Mahoney for confirming what I was thinking. So I ended up having a knowledge/concept issue rather than a real config issue. I thought that the call routing logic in a gateway checks potential matches before ...
Hi all, ended up opening TAC case. Problem was I was hitting bug CSCuu46430 related to DRF process creating logs without purging them, ence not finishing properly. https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuu46430/?rfs=iqvred Thing is, the on...
Hi Nithinthanks for your suggestion. I will try to reseat the controller tomorrow at office and get back to you with the results. However Im worried because at this stage the server is unresponsive no matter what key you press on the splash screen, I...