Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I know, Cisco ACE is a very age old product now, but one of our client is still using it and need help to configure new VIP.Network diagram is attached for easy understanding. (RED marked is working and Blue marked in NEW) - device is in bridged mode...
Hi Team,We are using Cisco SX20 for TP.I can call to remote site using IP without any issue, but when I dial IP##ext. ( 48.45.45.45##2002 ), the call is not placed,so we have to ask remote site to call us.Kindly suggest why this is happening or is th...
Hi,I have configured VSS between 4500X switches, show commands showing expected results,Scenario attached # Issue:When Cisco 300 switch is connected to Active [vss] sw, then I can ping server 192.168.0.10 and 20 which is conncted to 3750 SW, ...
Hi,I am using IronPort S160 ( 6.3). I am facing issue related Guest policy,AD authentication is working properly, but when I typed incorrect password, it is not using guest policy, and URLs are allowed,even I blocked in policy , pl check attachment f...
Hi,One of our customer just purchased ASR1002 router, they have three internet links from different ISPs and they dont have any remote site,they have three different public IP pool as their respective ISPs. So, is it possible to load balance the inte...
Hi Ashish,You must have to upgrade the IOS, because minimum software version support for this card is 12.4(20)T - IP BASE.Pl refer Table 1A in below document.http://www.cisco.com/c/en/us/products/collateral/routers/2800-series-integrated-services-rou...
Hi Ranji,Control plane functions refer to processes that are run in software, whereas data plane functions refer to processes that are run in hardware (ASIC).For backplane pl check below documents, in very depth explanation.http://www.cisco.com/c/en/...
Hi,These are the uplink options for Cisco 500 series#Stacking Option One (default option):• Ports XG3/S1 and XG4/S2 are configured as stack ports– Speed—1G, 10G, 1G/10G-auto– 5G is not available• Ports XG1 and XG2 are available as standard network po...
Hi Renji, As jens answered, IP##ext. ( 48.45.45.45##2002 ) is Polycom proprietary dialing method which is not supported by TANDBERG/Cisco systems.version is # 6.00HTH Thanks
