Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question regarding a C6800-32P10G module in a 6509-E chassis with Sup-2T.The module can operate in 4:1 oversubscription mode or 2:1 oversubscribed performance mode because the chassis backplane bandwidth is only 80 Gbps.Does this oversubscri...
Hi, I am running a VSS consisting of two 6509-E with Sup720 MSFC3. The IOS is a 15.1(2)SY2. I tried to upgrade to 15.1(2)SY5. According to the ISSU compatibility matrix this should work. I did a "issu loadversion", and as soon as the second superviso...
We have an ASA 5555-X running 9.2(1). It is connected to an VSS-1440 running IOS 15.1(2)SY4.They form an OSPF area, the ASA should distributes its connected and static subnets to the router via OSPF. It works fine for the subnets which are directly c...
Hi,we are running a VSS-1440 (Two 6509-E) with VS-SUP2T-10G and WS-X6904-40G. The WS-X6904-40G have FourX adapters installed. They are configured in non-oversubscription mode:#sh hw-module switch 1 slot 1 oversubscription port-group oversubscrip...
Hi,is it possible to use a Vlan interface (SVI) for syncing the switch profile on two 5596? I tried this:2 x 5596UP with NX-OS 5.2(1)N1(3)Connected with 2 x Twinax on ports Eth1/15 and /16, portchannel 3.The Po3 is a trunk, allowed Vlan is 439. Both ...
I checked once more according to the document you sent and found no problems in the config:
wiss#show redundancyRedundant System Information :------------------------------ Available system uptime = 4 years, 1 week, 3 days, 6 hours, 27 minute...
This was the output of "show switch virtual redundancy" before the upgrade. It was in SSO mode, hot standby.#show switch virtual red My Switch Id = 1 Peer Switch Id = 2 Last switchover reason = user forced Co...
