Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Had this issue and wanted to let you know how I fixed it with the scenario I was seeing. Seeing this message in my CX Cloud faults "AAA instability with server" condition %RADIUS-3-ALLDEADSERVER:.*. After running the below commands I was able to fi...
This URL talks about a vulnarability with IOS code. http://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-20120328-sshBut what is not clear is the following:Under the section "Software Versions and Fixes" look for "12.2SE". ...
We have a situation where some switchports are in a public area with Cisco IP Phones connected. We want to disable the ACCESS VLAN but allow the VOICE. Is it best practice to just remove the 'switchport mode access' command?
For some reason the Stored Device Credentials stopped working, authentication failed. However the same User/Pass works with the Application Update piece and www.cisco.com. Any reason why this could happen? I know I am putting the correct CCO User/...
We verified the same issue and also found that configuring Port-Security on 12.2(50)SE5 cleared the extra MAC ADDRESS. We removed Port-Security and the extra MAC showed up again. We were planning to move to Port-Security on these switches anyway.
