Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI all,
We are working in a integration of BGP +BFD for:
HPE 12904 Switch and Cisco ASR9000 XR 4.3.4 , but the status of sesión es ADMIN – DOWN.
For the Cisco ASR side we are using LACP (2 x 10GEth) with 802.1q and sub-interface and for the HPE 12...
I'm having an issue with the time on the IP phones (7945/7975) in a C2921 as CME.
I'm using IOS 15.4.3M4 with CME version 10.5.
In Chile we use GMT -3 round; then I set NTP and clock timezone GMT -3 in the IOS, also I set time-zone 18 in telephony ...
Hi all,
We have a 2921 like CME, with E1 controller, but we are waiting for PVDM3-32 to connect E1 PRI to PSTN.
Actually I have 20 SCCP phones registered on CME, but there is not dial tone when I pick up the handset and I cant dial between the phon...
I see this message "this key is not active here" on somes 7911..this was after that I upgraded from CCM 5.1.2.1000-11 to 5.1.2.2000-3.I tested this condition using a CIPC sharing the afected DNs, but the FWD works fine!...I ´ll check the correct FW o...
HI OliP,Regarding this "- MS Teams Outbound calls are masked on the SBC-SIP trunk inbound side within CUCM for signalling the CUCM exension of the user instead of his Teams phone number" you are talking about when a user is a MS Teams user and also i...
Thanks so much Amit!!!, please, can you comment about the documentation which suggest this (24 contiguos ports), I had not can find it.Thanks in advance!!Iván Garrido
