Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone have any information on configuring Easy VPN (EZVPN) Remote on an IOS XE device? Specifically on a 4300 series ISR. Again, I am looking for the REMOTE config, and not the SERVER config. When I try to go into the ezvpn configuration mode...
I'm going to try to keep this simple, but if need be I can map out a topology or upload some configs to look at. Thanks in advance for the help. 2 sites - one for production, one for DRBoth sites use same AS, both sites have same ISP.Production and ...
Probably a simple question, but my BGP skills are next to nothing....apologies in advance.Scenario:CompanyABC owns a /22 subnet of 1.1.0.0. The full /22 is advertised out of CorpOffice1 to ISP1. There is a route-map configured that uses a prefix-li...
I finally found some online help from others suggesting a formula for calculating the start/end/duration time of calls (sorry, I don't have the sources). I've incorporated these into an excel macro for exported CDR information. Not only does this c...
Cisco's recommendation was to migrate to DMVPN, which did work (and fairly well), but it was still a migration process and EZVPN is no longer supported.
Well, I answered my own question.Got in touch with Cisco and they stated that EZVPN Remote is not a capability on the 4321 platform. It can however do EZVPN Server (which is not what I need).
I realize this is a little bit of a dated post, but I wanted to inform others who might stumble across this. I had the same issue after renewing an expired certificate. I found the issue was with the VPN Gateway in CUCM. After I renewed the cert an...
I realize this is a little dated, but I wanted to let everyone know that I had these same errors/issues and we were able to correct it by updating the server certificate on the NPS server.
