Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am trying to test migration of switches from a legacy environment to vxlan. The vxlan is connected to Legacy 7Ks via double-sided vPC. The SVI for vlans will remain on the 7K for now. The vPC between the 7K and Border Gateway is up and on...
Hello,We have a GE Multilin P-30 Phasor Data Concentrator connected to a CGS2520 switch that sends data to an offsite Phasor Data Concentrator using multicast. TCP connections to this PDC work just fine when the switchport is configured as an access...
We are using 2921 routers as a Gateway to convert TDM (E1) from a radio system feed to an ip mulitcast stream. The radio device that is connected to the router VWIC is a New Zealand made Digital Audio Switch (DAS). The TDM to IP and IP to TDM is wo...
I have been used to the easy to understand output of the "show policy-map interface X" command, and now Cisco decides to change the look of the output just a bit in 15.x code which is not so easy to understand. More specifically the output of the co...
Hello,When configuring a class-map, I want to match based on DSCP values. I see that I can configure the match statement either as "match dscp" or "match ip dscp". The router accepts either one. Is there a difference between these two, or do they ...
I have the same issue, same error message, only rebooting the VMs did not resolve the problem. I see the IP address configured for the service "cisco-ndfc-dcnm-poap-mgmt-http-ssh" in the Admin Console/Infrastructure/Cluster configuration/External Se...
Peter, thank you for your reply.I fully understand the function of the priority queue, which is why I want to see more than just "b/w exceed drops:". At least with earlier code you also saw total bytes dropped. I know this isn't a forum for complai...
sorry, i have been on the phone with Cisco all day. My original configurationswere based on configurations supplied to me by the console maker, TPS, and looks to be somewhat old. The ds0 groups were configured at E&M Immediate-start, and Cisco chan...
I forgot to include the following as part of the configuration:voice class permanent 1 signal timing idle suppress-voice 1 signal timing oos timeout disabled signal keepalive disabled signal sequence oos no-action
