Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have UC infrastructure in version 11. We use SSO for all authentication. Also we use Jabber in all format.
Only on the Jabber mobile, also iphone and android device Don.'t store user credentials.
Every day users need to insert username and passwo...
Hi, anyone have this problem? I've One ATA190 (1.1.2 (005) Feb 6 2015) registered with CUCM 10.5.2, that when goes to SRST fallback, and then when Primary connection CUCM is up again, don't reconnect to CUCM but remain connected to the SIP SRST serv...
Hi all, I've a problem with DTMF relay only on outbound direction in this topology scenario:SIP ISP <---SIP--->Cisco UBE ISR 2811 <--SIP---> Cisco UCM 8.6.X <---SCCP---> IP Phone I'm using codec g711 with the provider that tell me to use in-band DTM...
Hi Roger, unfortunatly no. Communication beetween expe-C and CUCM is fine. From the log we see that Expe-C successfully pulled TFTP, and configuration from the CUCM but we cannot see any POST message to the expe-E. All SSH tunnel beetween domains con...
Hi Guys, same issue there, errors Only on the Expressway-E side (Dual NIC deployment with NAT1:1 on the outside NIC)
Event="get_edge_sso" Detail="Access denied" Reason="Only legacy auth supported"
Anyone solved?
TAC is opened but no solution in 72 ho...
