Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I listened to the presentation and Rowan stated that the price for the SX10 would be $1500 street. I requested a quote from my vendor and it came in at $2200. Have I missed something here? Does this $1500 price including User/Device Licensing?Than...
What does the message mean? I am about to migrate new 6.1 to replace 4.1 servers. The system seems confused because the provisioned IP Address is not the DNS address. Will this problem go away after the 4.1 servers are removed and the 6.1 servers ...
UCM 6.1(1a) I have configured the system to access the LDAP directory service from Microsoft Active Directory. How do I get the system to allow my users to login on the ccmuser page authenticating to Active Directory?
I am trying to configure a SIP to SIP gateway so I can get a SIP trunk through the firewall. Do I use Dial Peers to direct the traffic? The document gives me basics but not specifics.
Is there an image on the flash? if this is new then I think that there should be. Allow the unit to reload twelve times. If there is any image on the flash, the device should boot to it. Yes, I know it is a pain to wait for so long. There may be...
Heip,
Here is the answer to your issue:
WIC Slot 2:1 Port Gigabit Ethernet SFP/Copper EHWICWIC module not supported/disabled in this slotPCB Serial Number : FOC20133QX2
...
Sorry, but this WIC isn't supported in the router.
Joe
My manager was sitting in the audience there at Enterprise Connect. He heard $1500 street and now I need to tell him that $1500 street is actually $2200 plus a licensing fee. Irregardless of the licensing fee, a 46% price increase makes my sell rea...
