Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
I am planning to use Cisco 5915 in one of the remote sites, the Cisco 5915 will be embedded in enclosure box, my question is that our network is based on IPsec over DMVPN with EIGRP, dose cisco 5915 support and what IOS I have found two
...
Hi All,
I would like to place order for 4331 routers to support, Eigrp, IPsec over DMVPN phase,
what is the best license and IOS image to order;
are the following good options
SL-4330-IPB-K9IP Base License for Cisco ISR 4330 Series
SL-4330-SEC-K9Se...
Hi All,
I have the following situation; ii have the cisco 2911 router has layer 3 etherswitch module; the router is running EIGRP routing protocol, this router has backup sat link to a terrestrial line. the etherswitch has vlans and an internal tr...
Hi All, I have the following setup, 50 remote users are connected to HQ by satellite links (delay about 600 ms), each remote has 2 IP Phone where they are calling HQ.I don't have the option to add router(CM) for the remote can i use SIP protocol for...
Hi All,I have to design a network that supports up to 100 remote sites and one HQ site, all the remotes should communicate with HQ as Star network. At the remote there will be two telephone lines and one laptop. The remotes will be able to call HQ a...
Thanks Manish for your response.I understood the issue of have two CM servers talking to each other though high latency link.i am wondering about the performance of call setup for SIP phone through such links; since the phone should communicate with ...
Thanks for your reply, I will consider ASA for IPsec termination connections.I will leave the 3900 router at HQ for call processing and handling, my question is what the modules are needed to be add to the 3900 router in order to support call handlin...
