Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hii was wondering if anyone can contribute this behavior.we have Nexus n7k running 5.2(4), it seems the OSPF picks the inter area path to ASBR rather than intra area path, though the cost is much lower with intra area path.the topology:r1 and r2, bot...
hi all,just a simple question but i can't find definate answer on.in an OSPF network with multiple areas, is there a need to advertise loopback addresses (RID)? Can the OSPF network works without having the need to advertise it? my thought is becau...
hello,with Nexus 5000 having limitation of 16 port channels, does anyone has a list of what actually count or not count against the limit?lets say the scenario is- 2 N5k in a vpc domain- 2 N2k FEXes, and each FEX is doing straight through connection ...
hello,i read that should a switch be vpc member of parent Nexus pair, the parent Nexus pair ports should be normal ports.however, if a server is to be vpc members of Nexus pair, should the vpc ports be normal or edge ports?thanks in advance.
hello,i was wondering if both nexus 7000 vpc pair can be configured with the same vrf, and they share the same vlan segment? since both nexus have their own control plane, so both can configure the same vrf, and define svi interface in the vrf.i.e.ne...
hi,apparently, this symptom is due to change in RFC, from RFC 1583 to RFC 2328.where:- prefer non-backbone path to ASBR firstthis would be not preferred if ASBR is in backbone, or if non-backbone path will route through firewalls.there is option to m...
thanks for the response..all devices have dedicated physical interface for mgmt traffic like ntp and snmp, and no other interface is to used for mgmt traffic.Loopback will only be used for RID and not require network reachability, it makes more sense...
thanks Amit,i was shown this page http://www.cisco.com/en/US/products/ps9670/products_implementation_design_guides_list.html, in the chapter 6 file there is section specifically show which connection would consume hardware port channel resource.i.e. ...
