About martin1.plank

martin1.plank · 01-28-2014

Hi outthere,does anyone suffer the same problem?My Phone is registered at CUCM, CUCM has a SIP-Trunk to VCSc, MCU is registered on VCSc-Cluster.I can place a call to MCU and everything works fine.After except 15 minutes I lost the video on J4W with V...

martin1.plank · 06-14-2013

Hi,We are using VCScluster with two VCSc s. We are using one VCSe placed in DMZ using NAT to external IP Adress.With Jabber4Telepresence placed on the internal LAN there is no problem.Using Jabber4Telepresence placed to Internet we have problems.Publ...

martin1.plank · 05-26-2013

Hi,With the old scheduler it was possible to choose ISDN for callin participants.With SmartScheduler you can choose "Call-in Participants" and "Calling in on audio" but you can't choose ISDN so the prevered protocol is SIP.We have callin participants...

martin1.plank · 02-25-2013

Hi outhere,we installed tmsxn 11.3.1 it works fine for adding conference.I only do have problems by deleting a conference in Lotus.On tms-side I never see any packets.Logs on Lotus doesn't show the process because for deleting the TMSEventCatcher.dll...

martin1.plank · 02-12-2013

Hallo all,I've configured serveral permanten conferences on MCU 8420.Now I want book these conferences via TMS and TMSXN.How can I do so?kind regardsMartin

martin1.plank · 06-26-2019

hi, got same problem, is there any solution to solve it?

martin1.plank · 02-27-2017

Hi, At NPS we configure Regex to forward (relay) Phone-Request to ISE. At ISE we use eap-tls only for phones which supports it. But we are running POC! To run it within PROD there is a long way to go. kind regards Martin

martin1.plank · 01-31-2017

Hy Lappian, can u provide your solution to me. We are using NPS for 802.1x too. But our 802.1x guys are facing Problems with the AD Objects. How must the USER (Phone) be configured/added to AD to be used within NPS u can reach me at firstname (witho...

martin1.plank · 07-27-2015

Hi, because there is no parameter <RemoteAccess>OFF</RemoteAccess> within the doku, I didn't try ;-)Is this a hidden parameter??

martin1.plank · 07-26-2015

Hi,Can you tell me the way to do so when using JW4 10.6.1??

Member Since	‎03-23-2009 02:07 PM
Date Last Visited	‎08-11-2023 03:08 AM
Posts	145

User Statistics

User Activity

No Video after 15 minutes between J4W and MCU

Jabber4Telepresence Client disconnect after about 30 seconds

TMS 14.2 Smart Scheduler ISDN Dialin Participants

Delete in Lotus doesn't delete in tms by using tmsxn

Book permanent Conference on MCU via TMS and TMSXN

Re: Cisco 891F - Defective IOS and Password Recovery disabled

Hi,

Hy Lappian,

Hi, because there is no

Hi,Can you tell me the way to