Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I hope some one can help. We have several MDS switches in a customer network, recently they had to add more IVR zones, but when the customer try to add one new IVR zone SAN12(config)# ivr zone nameIVR_mxoccsapcwd01_fcs2_new_MXOCCSTGSV1_SV2_N1P7...
Hello.Yesterday we try to upgrade the ESXI for a ucs server (BE 6000) because we are hitting the ESXi 5.5 < Build 3568722 / 6.0 < Build 3568940 glibc DNS Resolver RCE (VMSA-2016-0002) (remote check) Vulnerability, but we were not able to do it and g...
Buenas tardes. Estoy tratando de configurar SSH en un MDS 9250i.Lamentablemente un compañero se salto los pasos del wizard inicial y no se pudo agregar.He tratado de configurarlo como en los switches de lan, pero no he tenido éxito.Alguien ha tenido ...
Hello. We are experience an issue with one AA application. It was working fine but yesterday it stopped. We are no longer able to heard the welcome prompt. I share the config. application
service app-b-acd-aa
param voice-mail 37118
paramspace en...
Hello.
I have a customer who has to move their cisco be7000 to a new location.
He decided to use new ip addresses for all the voice solution.
So I am wondering if I have to change all the ip addresses of all voice solution that is included in the b...
Hello Bhavin.Thank you for your answer. Right now the MDS device don't have PSS support. The Customer project manager is working on that. We have a troubleshooting session and we were able to notice the following trying to commit the ivr changes on t...
Thank You Jaime.
Do you have any experience changing the ip address to the attendant console advanced and a procedure to do it.
In the documentation I only see the procedure to change the hostname.
Regards
Yes we are using just one because in our lab we don´t have enough power outlet. But I have change the power supply configuration to work together and we got the same result.
We are planning to install this chasis back to the customer site the next ...
Hello Leo.
Thank you for your help and time.
Here is the information (since I am not able to get Access to the device right now, I took these information from the last show tech support I took.):
------------------ show module ----------------...
Hello Manish.
Thank you for answer.
I am thinking about licensing. The license that the MDS have would work with the new version?
or I have to re host them?
Regards
