I recently upgraded my EWC on C9115 from release 17.9.5 to 17.12.3.
As a result, the web management interface is extremely slow, and the lobbyadmin web page is also experiencing significant delays.
Does anyone have any suggestions?
many tks
Johnny
Hello,
I only need to manage remote anyconnect acces with LDAP or RADIUS authentication in a FPR HA active/standby architecture.
no NGFW needed and no other functions.
May I use FDM to manage FPR 2100 series and 3100 series?
Tks
Johnny
Hello, I need a couple of firewall to manage up to 1500 concurrent anyconnect connections.
the firewall need only to manage anyconnect remote access.
may I use a couple of FPR1140-ASA or FPR-1150 in load balancing? I would not configure them in failo...
My EWC shows wifi clients no longer connected.
In monitoring>wireless>clients I can see for long time even disconnected clients.
Is there a timer to fine tune?
Also: if I connect my iphone I can see two connections from it, one on 802.11n and the oth...
my wireless network is composed by 9100 EWC controllers.
Everithing is ok apart from apple devices which have poor performances. On apple devices I note very poor signal strenght.
Is there any special configuration to apply in order to let apple work...
I disabled Private address on Iphone and everithing is ok!
Many tks!!!
My session timeout is 1800, may I leave it with this value or is it better to change it to 28800?
Many tks,
I need 8-port HW upgradable rugged PoE+ switch for DIN guide.
I don't need any SD-access or feature other than simple ethernet PoE access in a compact DIN apparatus.
do you think IE-3300 will fit me and do you think IE-3300 is going eos?
tk...