Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi BoardI have problems getting an MP112 (Audiocodes) to register on a CUCM server. I have configured a user on the CUCM platfom, and a third party SIP device (Advanced). Assigned a new SIP security profile specifying that digest user should be used....
Hi CommunityWhat is the command to set both radios to run at 5 GHZ only. Our controller is an 5520 running 8.10.183.0. Most of the AP's is 9120, and they should be capable to run both radios on 5 GHZ.But I can't find the commands nesccsary to do this...
Hi Forum We have recently bought a few Cisco ISR1100 router with POE on the first 4 ports. They cannot feed the old 7960/7940 IP phones, but have no problems in feeding and Cisco 2802 AP. I suppose this has something to do with the non standard way t...
Hi Tech guysI have a customer with an WLC 5508 installation with Apple bonjour problems. Only one WLAN defined, all users and printers using the sam IP segment. All users are wireless, so are the printers. We are running 7.4.110 code on the controlle...
Hi ForumI have made a very simple test setup to check that a rogue DHCP is not allowed to pass out DHCP addresses to clients.I am using a linksys router, which acts as the rogue DHCP server. An IOS router connected to the uplink port acts as the trus...
Hi NithinI have configured af user with a local number, configured digest password and assigned the local number ti the user. And I have configured a SIP third-party phone, assigned this to the user.Just to compare I tested at the same time with a Ci...
AP name command is only for renaming an AP - so that is not the relevant CLI command on a 5520 WLC. Your suggestion via the GUI interface only kills 2.4 GHz, but it does not provide 5 GHz on the first radio.
Hi ScottI do think that we have tried to follow Cisco's best practice. Since all users are on the same subnet, the use of a Bonjour gateway should not be necessary. So we will have to configure the controller to forward broadcast and multicasts.We ha...
Hi scottAll printers and mac's are on the same IP subnet attached to the same Wireless LAN. The only thing the controller should do is to forward the IP multicast, but somehow it doesn't.Mac and pc can ping the printers, so basic ip communication wor...
Hi Xie YaoAll traffic is going on VLAN 171, and the IOS DHCP server is attached via a trunk to GI 1/0/28. The rogue Linksys DHCP server is also on VLAN 171.The strange thing is that the ip dhcp snooping database is not populated with any information....
