WLC 5520 and 9120 AP configured with both radios running 5 GHZ

[plillelund]

Hi Community

What is the command to set both radios to run at 5 GHZ only. Our controller is an 5520 running 8.10.183.0. Most of the AP's is 9120, and they should be capable to run both radios on 5 GHZ.

But I can't find the commands nesccsary to do this

regards

Peter

[balaji.bandi]

Wireless > Access Points > Radios > 802.11b/g/n > (select configure in dropdown option appear right side of the row for each AP) > Admin Status > Disable  (from GUI)

From CLI :

ap name <AP_NAME> dot11 24ghz shutdown

[plillelund]

AP name command is only for renaming an AP - so that is not the relevant CLI command on a 5520 WLC. Your suggestion via the GUI interface only kills 2.4 GHz, but it does not provide 5 GHz on the first radio.

[balaji.bandi]

Your suggestion via the GUI interface only kills 2.4 GHz, but it does not provide 5 GHz on the first radio.

Sure the Option i was provided thinking that you want to disable 2.4 and enable only 5GHz

check below option may help you - never tested myself both the bands using 2.4gh or 5GHz

https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/m_configuring_aps_with_dual_band_radios.pdf

[jagan.chowdam]

You need to enable Flexible Radio Assignment.

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-3/b_RRM_White_Paper/fra.html

CJ

/**Please rate useful responses**/

[marce1000]

 - Try (CLI) :  ap name ap-name dot11 dual-band slot 0 band  5ghz

 M.