About Teressa Corson

Teressa Corson · 10-09-2013

I have an agency that requested an 800 number from the phone company. They want that 800 number to ring to a specific user's DID that is in our CUCM. I'm not clear on how to do this. Does that routing happen in CUCM, or is it something the phone c...

Teressa Corson · 06-08-2012

Can anyone tell me what version of SSL is used by the AnyConnect client (version 3.0.1047)? Where would I find this information?Thanks.Teressa

Teressa Corson · 09-14-2007

I am trying to implement LLQ across several switches. Our Cisco IP phones are attached to 3560 POE switches that are configured only at layer 2. They trunk to a 6509. I want to set up egress queues on that trunk so that voice traffic has priority ...

Teressa Corson · 06-06-2019

stewart-ian, I second your questions. I'm struggling with the same issue on a new 4331 router. If there is a new way to enter the syntax, that would be my preferred path. However, I'm not finding any way to do so.

Teressa Corson · 07-09-2014

In case someone else runs into this issue. There is a known bug for CER versions 8.5(1) & 8.6(1). It is fixed in CER version 9.0.2.https://tools.cisco.com/bugsearch/bug/CSCua66336The workaround is to make the first switch the master.

Teressa Corson · 07-09-2014

Does anyone have a suggestion for this issue? I have the same problem. My hardware is different. I have a stack of 4 WS-C2960S-48LPS-L switches.All of the ports on these switches were showing in CER until recently when the switch stack went down. ...

Teressa Corson · 10-09-2013

Thank you! That would explain why I haven't been able to find any information on how to do it in CUCM! I appreciate the quick answer.Teressa

Teressa Corson · 07-05-2013

How do you know which flows have been permitted or denied? I have an ACL with logging on some permit statements and on a deny any any statement at the end. When I look at the log, none of the lines say whether the traffic was permitted or denied. ...

Member Since	‎09-14-2007 10:28 AM
Date Last Visited	‎08-02-2023 12:02 AM
Posts	14

User Statistics

User Activity

How do I map an incoming 800 number to a specific DN in CUCM 7.1.5?

SSL Version used in AnyConnect 3.0.1047

QoS for Cisco IP phones attached to layer 2 switch

Re: 3850 FUJI 16.9 code TACACS+ configuration

In case someone else runs

Does anyone have a suggestion

How do I map an incoming 800 number to a specific DN in CUCM 7.1

Re: Nexus 7000 ACL logging (OAL)