Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Quick question and sorry if it is a dumb one.
I have a client that wants a VPN set up, OK no sweat I rolled out an IPSec VPN using the Easy VPN wizard. Now the issue I run into is I'm testing on a windows 10 machine which won't let me install the...
Good morning! I am running into an issue in Call Manager 10. I have basic queueing set up on two hunt groups. Everything works fine except that when a call is in the queue, the caller hears ring back rather than MoH. I have the MoH audio source se...
Hi everyone. I have a bit of a tricky one here that I wanted to put to the community to see if you had any suggestions. I have a client that uses a B-ACD for inbound calls as they receive a high volume of calls and don't want clients calling in and ...
Good afternoon!I am working on a SG500 that is giving us some issues at a client's site and I have noticed that when I look at the mac-address table I will see the same MAC address show up in multiple VLANs. The switch is running firmware version 1....
I'm having an issue with the CME of one of our clients. At their main location they have a number of 7961 phones, as well as a single 7975, that are not receiving the call waiting beep. I have checked the configuration and confirmed that this setti...
Chris,
Thank you for your reply again. There are members in the group. I did look over the blog post and it proved to be very useful in telling me if our overall scheme was going to work (it won't).
Previously I was just calling the hunt pilot w...
I do not understand their delineation between shared lines and broadcast lines in this context. The workaround says to use a shared line, which technically I am using. I rated your answer because it was helpful but would like to know what separates...
Thanks for the tip about the upgrade path Mike. I got the switch fully updated but it continues to show the mac addresses of the phones in both the data and the voice vlans
Aaron,No the extensions don't have any of the call-waiting commands configured nor do the phones have that softkey assigned. Here is one of the phones/DNs in question as well as telephony services config all of the affected phones are configured with...
