Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have moved to another management product and want to shut off LMS and VMS, but retain ACS. CiscoWorks is an inherited product, unused by the current team (other than ACS), and I want to make sure to cover any gotchas. Any suggestions as to the pro...
Hello- I am tasked with building out an autonomous AP system with surplus 1242s (AIR-AP-1242AG-A-K9). The topology would be:LAN (trunk) -- AP -- (Bridge) -- AP Fa0 -- PC NICI need to provide a layer 2 VLAN access to a PC attached directly to the Ethe...
Hello- We have a 24/7 schedule to push CDR records to an FTP server from our CUCM Publisher. We changed the FTP server IP and I updated this under Serviceability > CDR Management. However, no CDR files are getting pushed. I verified the schedule is s...
Hopefully this is an easy one for you all. A customer has a need to forward VMs received on one DN to be picked up at another. If copies can be left in both mailboxes that would be nice, but is not a requirement. We are running Unity v4, and CUCM v6....
Running CUCM 6.1.4Hopefully simple question. We have a customer who wants a DN to ring to an external number simultaneously when dialed. Any suggestions on how this can be accomplished?Many thanx
Thanx Marvin. LMS, VMS and ACS are all separate servers -- hardware and software. So it sounds like if I remove references on devices and shut down the hardware servers I am good to go.
I realize I should have said UNtagged the frames on the trunk, but you get the idea.It is seeming like I am only able to pass one VLAN over this topology. Anyone have any other ideas?
In building this scenario, I ran into a DOH! moment -- where is the other side of the trunk? The Fa0 interface on the AP cannot be trunked (I think). However, some success: when I tagged frames in VLANID on the switch-side trunk with native VLAN VLAN...
To those who find this thread, I used this doc to figure out how to manually transfer files:http://docwiki.cisco.com/wiki/Cisco_Unified_Presence%2C_Release_7.x_--_file_get_CLI_CommandSpecific commands I ran:file list activelog cm/cdr_repository/proce...
