Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have two HA C9800L-C controllers, one in LAN, one in DMZ.
I have 9105 Teleworker AP used at remote employee house tunneling back to DMZ (using this guide: https://www.cisco.com/c/dam/en/us/td/docs/wireless/controller/9800/17-3/deployment-guide...
In our environment, we have Cisco Prime 3.4 and utilize the Wireless Site Maps feature. We have a Site Map setup with several hundred APs placed. I have had two issues where an AP (1815 or 2802) would randomly get disconnected on the network (PoE/Eth...
Is it possible to upgrade LMS 3.1 to Prime Infrastructure 2.1 by using the R-L-PI2X-U-K9? The description only lists "LMS to Prime 2.1", but I am unsure if I would have to upgrade to LMS 4.2 before initating the 2.1 upgrade. Would I need to first upg...
Hi,I was wondering if the IME-PAK and IME-90-UWL come with the CUWL-STD-K9. They say they are included items in the configuration, but are not showing up in the completed Bill of Materials.
We are running FMC/FTD with AWS VPC VPN. The IP SLA feature is available in 6.3 on our GUI, with the 'requirement' to tie the SLA to a static route to track it (the only way to enable the SLA i've found). I have tried this exact attempt (below) and w...
Yeah it's weird - no notification in Prime. It was removed from the AP Site Map after a few days offline before a cable reset to bring it back. The AP still had its statically assigned AP, and was in same AP group. We have over 100+ free RTU adder li...