Hi, I have done this a few times and am missing something but cant figure out what it is. I think I should have set Gi2/0/1 with trunk for Vlan 1 & 50 - it shows no trunk at all. Any ideas what i am doing wrong?   Thanks, Rich   Booting off of: c2960...

Hi, I am using PFsense as a router & setup a vlan 50 - i am looking to put 3 WAPS on Vlan 50 - to keep my kids off my work computers network.   I setup the Pfsense Vlan I followed a youtube video. End result is having PFsense give an Ip for Vlan 50 o...

Hi, I have a SG200-26P and was looking to get it to the latest firmware.   I am able to get it to 1.3.7.18 but it keeps saying the files are too big after that update.  If i try to go past it with any of the files I get this message: Upgrade/Back...

Hi, I have a SG500-28P switch & have had it for a few years.  I am noticing that periodically it loses its static IP, password, etc.  Just reverts to a factory setting.  i have reset the unit 5 times over the years.  I am using POE (about 20% usage)...

Hi, I am looking to make take a template from SPA504G #1 and using the TFTP protocol using hte config file to send to SPA504G #2.   I used the file here: http://192.168.168.199/admin/spacfg.xml then saved as a cfg file.   How do i send that config...