Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
is there any a quick and free solution based to add in the CUCM corporate directory ( not the personal directory) entries for outside phone numbers PSTN ( people that are not CUCM users) .
Thanks
Dan
Hello
I am planning a migration of an old CUCM system to CCUM v10. I could see the 9.3(1)SR4 firmaware is the earliest that should be installed on the phones, however could not find reference to 7910 and 7936 or 7937 CIsco Ip phones.
Is there anyone...
Hello,
I am looking for the confirmation that DSP transcoding ressources on CUBE ISR G2 can be used by the CUCM in a scenario where the same DSPressources can be used as transcoder for the SIP trunk connection to the ISP ( CUBE acts as SBC too). Is ...
HI I wonder what will be an agent status in UCCX 10.6 if his/her PC goes down ( finesse agent loses connectivity with UCCX server). We plan using Enhanced type licenses. Can the agent continue working with the IP phone only? Regards,Dan
Hi,I am looking for samples of design and deployment questionnaires for IPT. I want to be sure I don't miss any question in the case of a migration from legacy PBX to CCM4.1.I already have the SRND document, but it will help me a lot to see how other...
Hi Hythim,
Cisco UDS is a simple repository, I am not aware of a way to allow custom access to certain fields of a given directory ( mobile cell phone number field in the user_id record)
You may point your _cisco-uds SRV to a firewall or load bal...
Have you configured your fxs line in Call manager for the vg202 port 0/0?
Do you see the vg202 as registered? You may do the reset of the port via cucm GUi and not from the gateway itself.
Regards, Dan
Thanks for the quick answer, will there be a limit to the number of such entries? let's say I want to add 1000 of those on top of the 1000 users that curently have phones on a BE6000M
regards
Dan
Not sure the question was about how to configure SingleInbox.
In order to have a copy of the voice message to the exchane mailbox, you need to:
1. enable and configure the smarthost feature in CUC
2. Configure CUC to relay messages to SMTP server
3. ...
Hi Sirini,can you please point to the piece of cisco document supporting your statement?I was under the impression you could have a PUB CUCM VM sitting on a BE6000 and another SUb in the same CUCNM cluster sitting on a different hardware platform ( e...
