I call at the ADSL number and then the pvc is down. My adsl line is shared between a wic of router and the rtc telephone number. What`s the matter? Why?
i have bought a catalyst 6500 ( CatOS ver 8.3.5 ) with module:2 sup26 WS-X6148-45AFI can read in the logging:2005 Mar 04 13:45:51 europe +01:00 %SYS-5-OD_NOSCPPINGRESPONSE:Module 8 not responding... resetting module2005 Mar 04 13:45:51 europe +01:00 ...
I have a problem with a gprs connection.I have remotes router call out for gprs to central router.These call are good but the tcp sessions are stablished are misfire. My central router is connected to them by tunnels.My dialer in remote router config...
My ATMinterface is intermittenly UP-DOWN each 2 hours more and less and then the backup interface is UP . The ADSL interface is good . the only things I watch is on the dsl.When I through show dsl interface atm0/0 :BER Valid sec: 76401What do...
I have a problem in the atm interface,loss conectivity intermittent.I throw it thecommand:show dsl interface atmWIC Config Reg2 0x03 Gen bus error on bad ADSL accessInt 0 Enable Reg 0x03 ADSL normal interrupt enabled ADSL e...
configuration remote routerinterface ATM0/0 description El numero de la ADSL no ip address no atm ilmi-keepalive dsl operating-mode auto!interface ATM0/0.1 point-to-point ip address ip pim sparse-mode pvc 8/36 encapsulation aal5snap !!configuratio...
hello tomanderin!..your solution was very good. The central router bring up virtual access interfaces for each remote router. But the problem now is that they don`t ping ,only the ip address of the first call does the ping in spite of theirs routes a...
thank you tomanderin...i threw in "ppp multilink endpint hostname in the remore routers" and now el central router assign it its hostname but my problem now is when the second remote routers call in the messsage of debug q931 is Mar 29 21:45:21: IS...
