I know I have seen these all in nice rows and columns.It's driving me nuts... hehe. I check with Hyperterm and same thing... How do I get it back.Please see attachment.Thank you.
Hello,I seem to be getting this error message everytime I reload the router.amd_flash_cmd(): timeout on erase sector commandenvironment write to NVRAM failedI deleted a file from flash sslclient, and since then it's been happening.Any advice? Thank y...
Hello,CME 4.1The 2801 drops the first character on the phone. I do see it on the router using deb isdn q931.Display i = 0xB1, 'TELUS' however the on phone, it would displayed "ELUS" !isdn switch-type primary-ni!interface Serial0/3/0:23 no ip address ...
Hi Guys,CME 4.1I have search for the last 1 hour +, how the heck do I deregister a ephone?I have taken the ephone out, but when I do a sh ephone registered, I still see it. Something to do with the keepalive?Thanks
Hello,CME 4.1I am not sure what I am doing wrong. I want to restrict one phone from calling long distance. My config is...!dial-peer cor list long-distance member long-distance!dial-peer voice 113 pots corlist outgoing long-distance destination-patte...
Yes I second that. jb6846 is correct. WLC will not support more than one DHCP instance per client. However bridge mode can be use with the autonomous ap.
Thanks, but I think you missed understood. I am talking about the display/screen. They are supposed to be in nice neat even rows and columns. Please see attachment. :)
Nope. Didn't work. I get the error...access-list with 'log' not supported, pls remove 'log' from access-list otherwise class-map RDC_NAT will not work properly
