Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone integrated Unity as the i3 voice mail? I have seen some messages on this board but none seem to indicate it has been done. I would like to do something like a standard SMDI or DTMF integratio. I do see some ideas to try SIP which would ...
Does anyone know if CallPilot comes standard with VPIM support or is this optional? Does CallPilot support SMDI or other integration to Cisco while remaining attached and supporting Nortel users (dual integration)?
I am trying to design a solution using Callmanager 4.1 Q.Sig and using an Intuity voice mail on a Multivantage system. I have heard that somewhere within Cisco this is being tested but can not find a source of information. Does anyone know how to d...
I have a few customers inside of 8 miles with bridges. We have excellent signal. We are seeing throughput in the area of 19Mbps. We are told this is good. TAC has said 54Mbps is the radio speed and maximum speed "duplexed" is 27Mbps. I thought 8...
No. I do know SMDI is supported on CallPilot. However, I don't know if it is standard or an optional cost. I also don't know if VPIM is standard or optional cost but Nortel's site states it is a feature. Additionally I don't know if CallPilot can...
I have provided redundancy with analog ports. Install a dual integrated Unity IP and analog. Link it to FXS ports on the router and have SRST support those ports. MWI may not work but Unity will be able to run and be accessed in the absence of Ca...
Why can't Q.Sig be used with Intuity when it is available for use with Octel? I know they are different but with CallManager 4.1 and Q.Sig I would think the PBX would simply support this like it would a remote PBX on Q.Sig in an Avaya network unless...
