Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a customer who is using PIX525 and CISCO1720 (with VPN Accelerator) for site-to-site VPN.It has been working fine for more than a year when it suddenly stop functioning. When we did a "sh cryp ipsec sa", the tunnels were still alive and activ...
Hi,I wonder if anyone is facing the same recurring problem as me. The WebAttendant status line always appear RED though the user has signed-in and the phone is available.The method of resolution as advised by the local Cisco SE is to stop/start the...
I would like to change the SDLC VMAC address for some devices (due to a mistake made when assigning the address numbering scheme). I would very much appreciate advice on whether by doing so, will active connections be lost and need to be reset ?By t...
Cancel away the last statement - however take note that you cannot do a "no access-list 101 permit ip any any", because that will remove the whole ACL 101.Using a dialer-list will in fact reset the idle timer every time an interesting packet passes t...
Another thing that you may want to consider doing is to remove the following statement :-access-list 101 permit ip any anyHaving this statement effectively make all IP traffic interesting (other than those denied before) therefore the dialer idle tim...
I have faced a similar problem using OSPF as the dynamic routing protocol. Different from your scenario is, I am not using floating statics.In my case, when the primary link returns to service, I see 2 routes to each destinations - 1 through the pri...
This setup has been working for more than a year.One of the first thing we did was to compare the configurations of the PIX and routers, with the last saved working configurations. But we didn't find any discrepancies that will cause the VPN to fail...
I hope I am not too late in helping, or perphaps you already have the solution.I encountered a similar problem recently; I was able to ping the W2K, DNS and WINS servers through a VPN tunnel, but just couldn't connect and login.Well the trick is to u...
