Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I had a PC Softphone that connect directly to Catalyst 3550 EMI switch version 12.1(20)EA2. I would like configure qos, Knowing that IP Precedence 5 was default marking by Softphone appication, Can I configure the Cat 3550 to support this ?Can a...
I am having ACS, AP1200 and wireless Pc card.Some Pc card are configure without Leap enable.I would like to see the login activity message for those card that not Leap enable.Please advice that How to configure the AP or ACS in order to get the login...
I had a network setup with Pix 525 and CSACS version 3.0I would like to find out which Access control protocol best suite to my design.For Radius protocol. I am using the "downloadable Acl " ( Acl configure in Radius server, will push down to Pix whe...
Hey, I have a PIX 525 Ios 6.2Can I use one of the inside network's Ip addres for the use of virual telnet ?I had check the sample config from CCO.Most of them are using the outside network's IP address.If possible, provide me a sample.Else pls point ...
Thanks for your answer for quesion 2 & 3.As for question 1, I need the cable quality specification for reference.This info will help me to ironout the physical layer problem.Hope you can feed back me soon.Thanks
Hey Don,You are not answering my question.I am not require legacy 802.1d spanning tree Load Balancing.I am asking about new rapid spanning tree 802.1w & 802.1s.Could you provide this sample config.Thanks
Hey Steve,Thanks for your feed back.Just would like to confirm with u.Am I right to chose the "level 7 -debugging", in order to capture all logging traffic ?Could you help to explain the detail of the "facility" componet ?" Eight facilities LOCAL0(16...
