Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Somehow, my On-Prem SSM will not let me log into the CLI via any route I try - SecureCRT SSH, vCenter console, Windows Powershell SSH, etc. It tells me logon incorrect. BUT, the WebGUI operates fine with the local admin password. Being that I am r...
In May I moved from TDM thru 4431's to SIP thru 8300's. I have been trimming down dropped call issues, and up next is 102 codes.
This is sparse, but I am a fan of 99.999% reliability of Telecom. For example, from 1 July to yesterday we had 23,106 c...
CUCM 14SU3, SBC 8300 v17.09.04a
We moved off TDM PRIs over to new SBCs for all calling. Testing since November with no issues. We ported our DNs to the carrier on 17 April from our old carrier and I set up inbound calling to come in across the SIP ...
I'm working on migrating from TDM to SIP providers and built up my SBCs a few months back. I set up a predot (94) to send calls out as 10-digit for the VISP to route to a special DoD Phone network back in December and it works great.
This week we ar...
Yes! Thank you for this. I found the Deployment Guide and Admin Guide for these a few weeks back and they have been great at walking you through everything. After some playing with the configurator, Scan n go provisioning, and installing the devic...
Any Success Updates on this? I was just 'blessed' with 4 of these to replace older 8821's and 7925's we had, and looking to strip them down to just CUCM connected endpoints.
