Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hola necesito crear un nuevo SSID que solo permita el acceso a una URL especifica y bloquee todo lo demás, probé varias alternativas pero no logro conseguirlo.
Hello, I need to create a new SSID that only allows access to a specific URL and blocks ev...
There is a massive problem occurring on my network.
specifically the IP cameras, they began to appear as IEEE PD devices, it does not identify them as Cisco devices and it is not possible to see them by CDP.
I describe some points:
- Occurs only wit...
My client has 2 ASA 5545 9.12 (3) 12.Both are configured in LMS with your correct and verified credentials. but when executing any task, it reports a validation error.When trying to run a Compliance baseline, one of them does it successfully but the ...
Any updates on this bug? I have the same problem and I can't find a solution ACS Monitoring and Report Viewer keeps sends alarms of High CPU every 2 minutes.The top command outputs and internal values clearly show that this is a miscalculation. Regar...
Estimados, comparto mi problema para ver si alguien me puede ayudar.Cuento con dos ACS, CSACS-1121-K9, Version 5.8.0.32.6 (Primary y Secondary : LogCollector). Ambos ACS alarmaron por llegar a un consumo de CPU mayor al 99%.Necesito hacer un diagnos...
It occurs in different camera models (2600, 4500, 6000P, 3620, 3630).
all are cisco brand, support CDP and this is enabled correctly.
all the cameras were working correctly and were detected by CDP without problems until the failure began to occur....
Hello Leo, Thanks for your comment.attached show version.For the example I used a specific case, but as I mentioned this is happening in multiple switches (2960, 3560, 3850) with different IOS (cat3k_caa-universalk9.16.12.07.SPA, cat3k_caa-universalk...
