Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone.I have a SUP2-MSFC2 that once I boot it up, the Status and System LED's go straight to red and the Switch Load shows 2 "bars" and hangs there. I get no console output. Now this is in a 6509 chassis with a 2500watt power supply. I took ...
Hello all,I have done a couple Hybrid to Native mode conversion's in the past couple month's with no issue. Now I am having some issues. I have a SUP2-MSFC2 with 128DM on the SUP board and 512D on the MSFC2. We have tried multiple MSFC2's and SUP2's...
Hello All,I am testing a MDS 9216i. I have never touched one of these boxes before so this is my first time. I grabbed 2 "notched" CAB-7k-AC power cables and im using my stadard Cisco Console setup. I powered up the box and the two power's are showin...
Hello all.I am testing a WS-SVC-WLAN module and can't get it to come up. I converted the SUP720 to Native mode and it is running s72033-jk9sv-mz.122-18.SXD4.binNow when I boot, sh mod show the module as Status "other". Then after a few minutes it doe...
Hello,Does anyone know how to break a password on a ATA 186? I tried the factory reset sequence and it didnt work. It just asked for the password again.Thanks in advanceScott
Hello and thank you for your response. The thing is I get no console output at all. The minute I turn on the chassis, the Status and System LED's go amber and it does nothing. I can't enter commands, and I get no output.Thanks for your time.
Well sir you are correct, it works now with the addition of 512D on the SUP. I always thought the memory requirment was only for the MSFC2. Thank you kind sir and have a good day
Thanks Ankur,The HW is 1.0, FW is 7.2(1) and SW is 8.3(0.156)ROThat info is from the "show mod" command on the SUP720. I can't get any console output form the WLSM.Thanks
