Hi,I'd really like to know what the ISE tacacs+ command set is for all interface-specific subcommands. " Permit interface* " gets me into the interface configuration mode, but nothing within that mode. Is there a one-line command set that will inclu...
Hi
I would like to configure a couple of 7960G's using a 3750 switch but currently stuck on upgrade screen.
I have performed a hard reset of both phones and connected both to a 3750 switch with vanilla settings. The switch is the only source of ...
Hi there
I need some help with a company merger type scenario.
I have two sites: A and B. Site A runs OSPFv2 while site B runs EIGRPv6.
The topology of the main routers is quite basic:
Site A R1 <---> Site B R1.
Both of the main routers ar...
Hello,
I am creating a lab network that has NAT and an IPsec tunnel.
Since implementing NAT both on a packet tracer activity and physical equipment, I have encountered issues with communication over the tunnel. Prior to applying NAT, I was able t...
Hi all,
I am setting up a lab and need some help.
My environment consists of two sites. Site A and B. Each site has vlans 10, 20, 30, 40, 50 and so forth, but each respective vlan on each site has a unique subnet. That is vlan10 on site A has a ...
hi Rick.
Yes, you are correct. Site A runs IPv4 with OSPFv2 and Site B runs IPv6 with EIGRPv6. It's a company merger type scenario challenge where each site runs a different protocol version.
As far as using Cisco models for the environment, it w...
Hi Rick,
Thanks for having a look at the configurations. I checked the switch at Site-A and you were correct in that g0/1 wasn't in trunk mode. This prevented necessary communication to Site-A LAN. So for helping me discover that I have marked your...
Hi all,
Thank you to everyone who has replied.
Okay, good to know I can use the same vlan name for different sites. I tried doing this on PT but clients at both sites weren't getting DHCP addresses. I'm not sure if it's a limitation of PT or I ha...