Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I tried to configure SNMPv3 for the N9K switches, but I could only find the SNMP user template and could not find the SNMP group template.Could anyone advise on the correct template name? or how to configure it without freeform.
Dear Team
Could I utilize the CW9800H2 Forty-Gigabit interfaces along with the 10-Gigabit interfaces, or are there any limitations?I am planning to use two Forty-Gigabit and three 10-Gigabit interfaces.
Thanks and best regards
We have two datacenters, each hosting multiple Cisco Catalyst 9800 Wireless LAN Controllers deployed in both SSO (Stateful Switchover) and N+1 redundancy modes. These datacenters are connected to multiple IDF locations using Layer 3 routing between a...
I need to know what the access points' joining procedures are in SSO deployments and N+1 deployments, and what the timers are in each section. For example, in SSO, if the primary controller fails, what will happen with the access point, and if it com...
I have 10,000 access points, and I need a wireless controller that supports this number, as the 9800-80 supports only 6,000, so please suggest a solution for me.
M02@rt37 Did you test it before? It is not allowed for me to use trial and error in the production environment.From the normal logic, snmp_server_host_trap is not related to the SNMP server group, as they are different commands.
@MHM Cisco World
The both Forty-Gigabit (40G) interfaces will handle the access-point traffic and normal user traffic in port-channel throughput will be 80G , The other 10G interfaces for specific SSIDs like Guest ...etc. so if i used three more int...
