Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Every one I want to install Cisco Access Registrar 5 on two different servers in active/ active designWhat design or requirements for active/ active deploiement ?Using Sun Solaris ? (i know using sun Sloaris i can have this mode of high availabil...
hiBefore in a datasheet like datasheet of AP 1131 we can find the indoor range and the outdoor range but now with the new Access Points like 1040 or 1141 we can find nothing about the approximative range in meter for indoor and outdoor ..My questio...
FR:J'aimerai savoir si le GLC-T ( connecté à un des ports Hosts du Cisco Nexus 2232PP) supporte 10/100/1000 Mbps ou 1000 Mbps seulement ?EN:I want to knew if a GLC-T connected to a host port of Nexus 2000 (2232PP) is considerated as a 10/100/1000 B...
hinormaly both of X2-10Gb-SR and XENPAK-10GB-SR will work because all use the same wave lenght look hearhttps://supportforums.cisco.com/message/3306651
hi,Why no one can respond at the question asked by Mr Ian Newman ? :I see the maximum switching of the Supervisor 7-E is 848 Gbps. If the largest chassis is 10 slots and they are 48Gbps each how would you be able to get 848 Gbps of data in to the ...
Think you Jeye I had hoped for an answer with more technical document than the datasheet because some times we find in the datasheet writed 1G for GLC-T and it appears by the table of the compatibility matrix it can support 10/100/1000 Mbps ; ...
