Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Wireless AP client unable to get dhcp ip from cisco WLC (when the underlay connection is over VSAT link)... We have two WAN connection to the HQ office where WLC is locatedOn cellular 4G wan connection, the clients work fine on AP. but if they switch...
Hi all, Need some help with cisco router booting into Rmon mode...when I reload it is going into RMON mode.... cisco ISR4351/K9 (2RU) processor with 7932457K/6147K bytes of memory.Processor board ID FDO2349M1RP3 Gigabit Ethernet interfaces2 Cellular ...
Hi All,We have remote site connected via two ISP (4G and ethernet) connection and is using DMVPN to connect to HQ. The DMVPN is currently setup successfully over the 4G internet but I need to configure 2nd internet connection as a backup to 4G. Giga...
Hi,I am trying to replicate the same setup in the youtube link below. The cisco IP phone 7942 is connected to internet connection via BGAN (VSAT internet) connection. As per Cisco MRA docu, cisco 7942 doesnot support MRA, so not sure how this phone ...
On WLC debugs, we are not getting EAP response from client on non-working scenario:osapiBsnTimer: Nov 08 16:50:31.207: 84:ab:1a:c7:91:42 802.1x 'txWhen' Timer expired for station 84:ab:1a:c7:91:42 and for message = M0*Dot1x_NW_MsgTask_2: Nov 08 16:50...
Thanks for your prompt reply. Is it possible to implement it with single tunnel on the hub as I dont have access to the hub config and is managed by HQ team?
Thanks for your response. The BGAN internet satellite terminal is purely internet connection and doesnt support vpn setup, I think probably set as SIP phone...Thanks for your help.
