Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have some WS-C3560CX-12PD-S switches and when I try to get them added to CER, I get the following message in the logs:This device is not supported I have a WS-C3560CX-12PC-S switch and it is supported on CER. When I compare the software versions:Sw...
I noticed that I have a backup job that I cancelled and it is hung up and never finished. How do I go about getting this resolved. I have tried to force to cancel the backup through CLI but that did not work.
With the introduction of the 988 Suicide Hotline, I need to make sure that my Cisco phones can call this. I need to set up the Route Partition in CUCM 11.5 and on my 4331/4351 ISRs. I think I have the ISR config figured out but I need help with the ...
I have a Cisco 7841 that was originally created as a 8861 so the requested phone load is incorrrect. Phone TypeProduct Type: Cisco 7841Device Protocol: SIPReal-time Device StatusRegistration: Registered with Cisco Unified Communications Manager Sanch...
We are setting up TACACS with ISE. The issue we are having is that when it is setup on a switch, we get "Authorization failed" even though privilege is set to 15. Here is part of the config: aaa new-model!!aaa group server tacacs+ ISE_Groupserver nam...
This doesn't work on the 7841 like it does on the 79XX series. I have tried this as well. I have tried the following too:Bootup as normal.Go into Settings and press ##*. Press the Erase softkey. When I try this, there is no Erase softkey.
