About Anthony Brandelli

Anthony Brandelli · 08-24-2015

I've had a good look around and can't seem to find documentation referencing the ability to use DHCP to hand out addresses for AnyConnect clients using IOS, only pools defined on the router. Does anyone have an external DHCP server handing out client...

Anthony Brandelli · 05-05-2015

Wondering if anyone else is seeing issues with 12.2(55)SE10 on 3560Gs/3750Gs where login's via SSH record a source of unknown. Failed or successful login's both exhibit the same issue. Example: May 5 14:00:21 MST: %SEC_LOGIN-5-LOGIN_SUCCESS: Lo...

Anthony Brandelli · 03-23-2015

First off this issue has existed since implementation, and I'm just curious if anyone has ideas on how to make improvements in performance, if at all possible. The problem is that after the phone goes off hook the first second of audio is either garb...

Anthony Brandelli · 12-11-2014

CUCM is working fine with TLS/SRTP between phones, just looking to secure the SIP trunks to CUC, and to CUBE. From CUBE to the provider will have to just be plaintext, since the ITSP doesn't support TLS. I assume the above is possible? I did give th...

Anthony Brandelli · 09-18-2014

I've run into an issue where callers coming from the PSTN do not hear ringback after being transferred using a Cisco Unity call handler. Ringback works internally between phones, and also works internally if I dial the call handler DN and request a t...

Anthony Brandelli · 12-04-2015

AnyConnect can use a variety of transports. Are you using IPSecV2? DTLS? Or just TLS? I have AnyConnect deployed on some ISRs and the performance with DTLS enabled (UDP) is pretty decent. I also played around with IPSecV2, but didn't notice any perfo...

Anthony Brandelli · 10-09-2015

What's the status of the array/controller/physical drives in CIMC? What RAID level is configured? What was the configuration of the old server for RAID/controller/drives?

Anthony Brandelli · 10-09-2015

Not sure why it's not listed under the 2960x but it's the same driver here: https://software.cisco.com/download/release.html?mdfid=282867574&softwareid=282855122&release=3.1 I'm using this on Windows 10 and Windows 7 hosts with minimal issues.

Anthony Brandelli · 09-22-2015

Not much you can do with two disks, you can either create a RAID1 mirror and then partition the resulting 500GB logical drive in Windows, or create a RAID0 striped array and partition that in Windows (Not advisable in my opinion). If this is data you...

Anthony Brandelli · 09-22-2015

Enable:debug ip dhcp snooping eventdebug ip dhcp snooping packetGet the client to try and renew/request an address though DHCP and see what the debugs say is happening.

Member Since	‎09-03-2012 07:02 PM
Date Last Visited	‎05-29-2019 12:06 AM
Posts	124
Total Helpful Votes Received	33

User Statistics

User Activity

AnyConnect/WebVPN IOS and DHCP

3560G/3750G

7925g Slow Audio Cut Through

TLS to CUC + CUBE - Audio Issues

No Ringback from SIP Provider after Unity Transfer

AnyConnect can use a variety

What's the status of the

Not sure why it's not listed

Not much you can do with two

Enable:debug ip dhcp snooping