Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,we want to purchase BE6K servers for our lab and use the Cisco VM planning tool (www.cisco.com/go/vmpt) to check possible VM deployments for the new platforms. On current BE6K-M3 servers, there are hard caps for the maximum number of UC applica...
Hello,I noticed a strange behaviour on an ACS 5.3 server regarding the Active Directory connection: The ACS is connected to the domain, the connection is established and rule-matching against the AD works fine. But when I hit the "test connection" bu...
Hello,I have a problem with the time synchronization via NTP between a Catalyst 2960 and Catalyst 6509. When I configure the 6509 switch as a NTP reference on the 2960, it does not synchronize with the 6509's NTP server. There is no reachability or A...
Hello,registration of some 9971 phones in a fresh CUCM 8.0 environment fails constantly. The phones ran without problems in another CUCM 8.0 before and have the "old" config still active (because they never registered to the new cluster). The log ...
Hello,I looking for a solution to the following scenario:Our customer uses the prefix 59 as PSTN access code, so incoming calls from PSTN are prefixed with the 59 to allow direct callback from the call history. This is done in the device pool (Incomi...
Hi there,you want to place the 1700 router in your LAN behind your Actiontec router, did I get this right?So, you need to configure your router interface connected to the Actiontec with IP network 192.168.1.0 (i.e. IP address 192.168.1.2) and a stati...
Hi there,please refer to the following white paper:http://www.cisco.com/web/partners/downloads/765/tools/quickreference/routerperformance.pdf First, be aware that the answer to your question strongly depends on your individual environment, especially...
Hi Tom,from a quick glimpse, your config seems good. As only 3 testing hosts are affected (according to your schematic), did you already verify that your issue is not at the host side, i.e. missing default gateways or desktop firewalls blocking ICMP ...
Hi guys,after weeks of figuring out this issue with the Cisco TAC we finally solved the problem. I just want to share the solution with you - it was an IOS bug, plain and simple: NTP packets received but ignored by the NTP processhttp://tools.cisco....
