Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
similar to some conditions mentioned in this bug, running 10.3.4a code, what we saw with arp-suppression enabled for a vni with svi, when a cluster node failed over , the mac of new node wasnt learnt properly especially in a c...
Hi,Is MGMT0 port really needed to connected for NDI ? for ndfc we were planning to use only a front panel FP connected to every vxlan switch going to separate switching infra not in the vxlan fabric and routable over data subnet of ...
Hi, So my question is pretty basic. The C series servers act independently and can be managed by fabric interconnects does that mean they have built in fabric extenders on board that connect behind to FIs? so B series they have to be ...
Above is my simple toplogy .vrf tenant-1vlan 101--l3vnivlan1000-vni 5000vlan1001-vni5001 but i cant ping to other vni switch(host). I learn mac and ip but ping just doesnt work. I am using latest code 9.3.5 on N9k's.iosvl2-0>ping 192.168.0...
hi,I know its very old thread. I am in similar situation where i havea static null0 route and i advertising that with aggregate address command like below and not seeing aggregate.ip route 100.65.240.0/22 Null0router bgp 4200070001addre...
hi @yasir.ilyas ,in IOS XR BFD is always configured under the client (ISIS, OSPF, BGP, static route, etc.). Only in the case of BFD Over Bundle (BoB) you configure BFD under Bundle-Ether interface configuration. Even in that case, though, you are act...
hi Alex, very good article and great guide. One thing that i feel missing info to clarify for BLB feature to use is only static BFD supported or i can use for BGP as well? We are running like 6.7.3 code but When i go under subinterfa...
