Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have ports configured for both 802.1x and MAB. Clients that do not support 802.1x with authenticate using their MAC address. I have noticed that even though a client successfully authenticates using their MAC address the switch will continuou...
Hello, I have an ASR router with multiple IP interfaces. Is there any way to restrict SSH access to the management interface only (gigabit 0)? As of now the router is reachable via any of the IP interfaces. I know I can create access-lists an appl...
Hello,
I am new to UCCX scripting so please bear with me.
I am using the 'Select Resource' option to direct calls to a CSQ. Agents are in a 'Ready' state and the phones are ringing, however I want to break out of this endless loop if nobody answ...
Hello,
I am no expert so my apologies if this question comes across as silly. Please see the attached topology, it is a centralized model in which "Remote site A" and "Remote site B" connect to "HQ" via L2 extensions, and then connect to one anoth...
Hello,
I have two ASR 1001X routers configured with HSRP and IP helper addresses on the interfaces for DHCP address assignment. I'm currently having an issue that's been observed when two routers in HSRP, configured with helper-address forward the...
Hi Paul,
Please see attached.
There is a L2 extension between Remote A and DC which acts as the primary link.
Remote A --> DC - across LANex
Remote A --> Internet - across LANex out from the DC
Remote A --> Remote B - across LANex to MPLS network...
Hi Paul,
Thank you - unfortunately the topology is a little more complicated than depicted and the routers are necessary to make dynamic decisions should certain links fail (there is a redundant link between Remote A and Remote B that is only utili...
Thank you - this was the solution/workaround that TAC provided as well.
Just for reference, the commands would look something like below (applied on the STANDBY device only):
event manager applet HSRP-8-Up authorization bypass event syslog patter...
