Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Could anyone validate this approach for updating our ESXI from v8.0 u3g -> ESXi 8.0 u3k please?Downloaded the vanilla image from VMWare for 8u3k from Broadcom site: VMware-ESXi-8.0U3k-25595708-depot.zipDownload Cisco_UCS_Addon_ESXi_80U3i_25205845_8.0...
Does anyone know if we can release the mic RJ45 cable directly beneath the mic (at the mic end) please?It seems to have some torx screws and I haven't yet tried opening up the connection box. Drawing 1, Page 1 on this PDF shows what I'm talking about...
Does anyone know why we see no default copp ACLs on a new C8300 router?router# sho run | sec control-plane
control-plane
router#sho run all | In copp
router#sho run all | in system-cpp
router#sh policy-map control-plane
router#Our Cat9400 and Nexus s...
Does anyone know please, if it's necessary to have these commands set on the wlan in order to get the APSP upgrade to work smoothly?wlan WL-CorpWifi 20 CorpWifi
bss-transition
bss-transition disassociation-imminentI think these may be on by default...
Does anyone know why the old Flexconnect config guides required the AP Management VLAN to operate as both the native VLAN and as a tagged VLAN? This no longer seems to be the recommendation in the latest guides.Old Guide for AirOS v7:https://www.cisc...
@Steven Tardy A great answer, thank you Steven! I'll send Sherlock to this thread as well because it's not been so clear.Could you explain at what point we needed the Cisco custom image? Was it only at the original install, or is it for major upgrade...
It's been a while, but I think the issue was fixed by Cisco introducing:RTPLib is enhanced with addition of a new API - EpOpenById_Symmetric(). This API should be used instead of EpOpenById() in order to deal with the problem. Of course, apps which u...
That command is shown in the original post but it's coming back empty. The c8300 model is the Cisco Edge router (not the G2 'Cisco Secure' routers). I'm just surprised to see factory copp policies on internal Cisco kit, but when we come to configur...
I had almost the same issue between NXOS (v10.4) and FGT (v7.2).show interface counter error non-zero -> IntMacTx-Er was incrementing
diagnose hardware deviceinfo nic portxx | grep err -> rx_err and rx_over_err were incrementingAfter a long while fre...
