Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We have a stack of 3 x Cat3850-48T-S switches (no PoE). Each switch has one 350W power supply. Here's the output of the "show stack-power detail" command:
Power Stack Stack Stack Total Rsvd Alloc Unused Num NumName ...
Hello, We have an 8.0.3 CUCM system that is beginning to be short on DLUs. I would like to know if it's still possible to buy UCL Licenses for CUCM 8.0 and install them on this system, or if we have to upgrade to a newer version. I'm asking because I...
Hello,I would like to change the message playback order to oldest messages first in Unity Connection 8.6. I know how to change it user by user and how to change the template, but is there any easy way to change the 400+ users that are already importe...
Hello everyone,I just installed Cisco Prime LMS 4.1, and now I want the user authentication to integrate with my TACACS server. I try to add my users with the same username as they appear in Tacacs, but in LMS when I try to add a user that has a dot ...
Hello,I'm trying to configure VRF-Lite on a cat6506, Native IOS. I can define the different VRFs, but when I try to put an interface into a VRF, the system tells me that VRF is not supported on that interface. I tried it on a physical layer-3 interfa...
Hello,
So if I understand correctly, each switch reserves 280W for operation, even if the switch does not actually consume that amount of power (the datasheet says that a 3850-48T switch with a 4 x 10G NM actually uses about 120W).
Then if I unplu...
Hello Rob,Every time a packet passes through a router, the source and destination MAC addresses will change, which makes MAC addresses locally significant only. If we assume that there is no NAT involved in the conversation then the source and destin...
Hello Gene,The routers have a function that is enabled by default that's called "proxy-arp". The PC with the wrong gateway will still ARP to get the MAC address of this IP address. This ARP will be a broadcast at layer-2, so the right default-gateway...
