Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a wired issue, I am trying to put my DMZ VM to outside do 1:1 NAT. It can not hit the NAT rule. For internal, the server is working fine. I disable the firewall of VM already.for the external, I put myself computer on the public IP addre...
I have new 8831, and i am using CME :Cisco IOS Software, C2951 Software (C2951-UNIVERSALK9-M), Version 15.4(1)T1, RELEASE SOFTWARE (fc2)
the 8831 can get ip and goes to voice vlan. I can ping the phone ip by CME, but the phone just keep showing Ph...
I am trying to set up an IP phone over VPN; the topology is attached. In location A, I can reach file server from location B and DNS server in Location C, and I can ping and telnet to CME by 10.0.45.0/24. But my phone can not register to CME, and my ...
I have a problem with busy tone, some of my users try to call one internal phone, it gets the busy tone right away. the configuration will post below ephone-dn 10number 104label xxdescription xxname xxcall-forward max-length 11call-forward busy 700c...
8.8.8.8 is an example, just in case, I don't want to send my public IP to everywhere.ASA# sh xlate local 192.168.27.137
1104 in use, 5491 most used
Flags: D - DNS, e - extended, I - identity, i - dynamic, r - portmap,
s - static, T - twice, N ...
show running-config ipqos
!Command: show running-config ipqos
!Time: Tue May 28 14:12:47 2019
version 6.0(2)U6(7)
class-map type qos match-all Low
match dscp 8
class-map type qos match-all High
match dscp 56
class-map type qos match-all Medium...
