Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using cisco 3845 router as voice gateway and running voice serice over that using E1 which is connected to a EPBX.I am using only 3 dial-peers (2 for VoIP and other one is POTS). I have 20 sites with similar kind of setup and have 2 gatekeepe...
Hi,I am using cisco 3845 router as voice gateway and running voice serice over that using E1 which is connected to a EPBX.I am using only 3 dial-peers (2 for VoIP and other one is POTS). I have 20 sites with similar kind of setup and have 2 gatekeepe...
Hi,I am using cisco 3845 router as voice gateway and running voice serice over that using E1 which is connected to a EPBX.I am using only 3 dial-peers (2 for VoIP and other one is POTS). I have 20 sites with similar kind of setup and have 2 gatekeepe...
Hi,I am using cisco 3845 router as voice gateway and running voice serice over that using E1 which is connected to a EPBX.I am using only 3 dial-peers (2 for VoIP and other one is POTS). I have 20 sites with similar kind of setup and have 2 gatekeepe...
Hi All,We are using Wireless Broadband and having ISDN as a back up for Internet.AS I said for Internet so we can not create any tunnel with service provider.My router is connected with wireless CPE through ethernet which never goes down unless and u...
ACL to restrict destination E.164 nos.?Is it possible? I have never seen that.If you are thinking to block traffic to that destination IP add, actually that is not possible because destination IP address is H.323 gateway to PSTN network. This gonna ...
Hi p.bevilacqua ,Yes, I could do it that way also but that is not gonna save my bandwidth use till destination for that particular voice channel.If we block it at the origination point, we can save our bandwidth and an additional task for gatekeeper....
thanks for the reply shanky.in case of tcp it establishes the connection but when there is udp and ppp combination, which protocols establishes the connection.And how the hdlc is connectionless?This all is confusing me.
Though it has solved my problem to some extent but the mystery is still unsolved completely because once I use the 'do' command, I can create more then one user with level 7 password at the same time without using the 'do' command again for each user...
