Hi, anyone else noticed getting double ringback tone (voice message from ITSP & local ringback tone simultaneously) when dialing an unassigned number in PSTN using Jabber for Windows over SIP trunk with CUBE? Tried with 12.6 & 11.8.5, CUCM is 11.5(1)...
Hi,
I have a pair of S380 web security applicance running 8.5.2-027 in active / passive mode.
The active one for a specific url eg www.something.com ; in the policy trace and in user requests shows that the category for this site is Games.
The pass...
Hello,We are running jabber 9.7 for windows and we have a small problem that is difficult to reproduce consistently. Some of our users, when they start up their computers, sometimes they receive a message "GDIPLUS.dll is missing" and the Jabber appli...
Hello,Using a 4402, ver 4.0.185, I'm configuring a WLAN with no layer2 security, and I have configured the web-policy layer 3 security method with a preauth acl to allow connections to a couple of vpn concentrators for unauthenticated users. Everyth...
Hello,I have a setup with a few 1242APs running IOS 12.3(8)JEA1 and have configured PEAP with EAP-GTC and WPA2 using ACS 4.1.I would like to disable Proactive Key Caching. Is this possible?If not, how can I clear/see the PKC cache on an access-point?...
Hello Paul,not really, we had bigger problems to solve and did not invest any further time on it (I can't even remember which destination was triggering the issue to test again). Kind regards,John
Hi, I have seen this bug, but in my caseJabber receives 183 with SDP -> 180 without SDP -> 404I don't see "ignore-early-media=true" in Call-Info 404 comes after the ITSP generated tone (voice message) and the CUCM generated message (from annunciator)...
Hi, The signalling is TCP based, there is a second INVITE to ITSP, but for authentication purposes. Just a note, the SDP(inactive) at 10:42:47.369 refers to the inactive video & application leg, not the audio. The second 183 with SDP from the ITSP s...
