Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!CLI Analyzer runs a few initial show commands when you ssh into a device, however, those sequence of commands cause the program to exit out of NCS540 devices since it's cli hierarchy is a little different from other IOS-XR devices like ASR9k.I ...
Hello everyone,I'm trying to migrate a working eem script on IOS to IOS-XR. Basically want to rename interface description whenever lldp neighbor changes.Here's the working script on IOS/IOS-XE device:event manager applet AUTO_UPDATE_NEIGHBORevent ne...
I'm trying this on NCS540(XR 7.3.1). Looking at an old Cisco live presentation(screenshot attached), neighbor discovery events were not supported in XR back in 2014, unable to new information on it.
I see that there is an MTU mismatch between the two PE routers. Fix that and see if that does it...
Outgoing Status (PW Status TLV):Status code: 0x0 (Up) in Notification messageMIB cpwVcIndex: 3221225480Create time: 19/06/2017 14:24:55 (20:48:10 ago...
Assuming you are tunneling those l2protocols across your PW? If yes, you might be right about the rate-limit. For ASR901 platform, there are such rate-limits and I'm pretty sure ME3600 being in the same portfolio has such limitations. I would recomme...
Look at using Integrated Routing & Bridging (IRB) or routed VPLS.
You can create a bridge-domain on R1 with a PW connecting R3, and a bridge-domain interface (BDI).
