Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently upgraded to CUCM 10.5 and CUC 10.5 using an e.164 dial plan throughout. One snafu that has surfaced is how do people access a CallHandler via the Greetings Administrator TUI if the CallHandler extension begins with a '+' character? Pressi...
The bug report indicates that this is fixed in version 3.0(3a). We just upgraded to this and I don't see anywhere to set up email alerts. Any ideas or documentation around this?
You can see the speed of the KVM mapped ISO transferring to the host if you select Tools --> Stats from the KVM menu bar. Depending on a number of factors I've seen it go anywhere from 3Kb/sec (-45 mins) to 15Kb/sec (~10 mins). At least this way you ...
I'm not able to connect at all to loopback@rtp.ciscotac.net
A few weeks ago I was able to use loopback@cisco.com, loopback2@cisco.com, and loopback3@cisco.com, but not anymore. I was able to test with one of our vendors on a couple of private B2B cal...
I would also advise that you load 8-5-2 firmware into your CUCM 10.5 and use the corresponding termXX.default.loads files to future proof the phones in the event any of them need factory resets down the road. Without this, the phone will get stuck in...
