Dear experts, I have attached the current design of my small office network. please suggest me the best configurations for this design and any amendments in the current design if required ....
i have a cisco switch 48 port and 2 are gb ports and I have 4 servers and most of the ports are directly connected to the users i.e access port and some are going to the tp link switches(then to the users) and some are going to the printers and some ...
I have Cisco 3750 switch which is connected via console comm5 port to my laptop and in the same laptop I have installed a kiwi Sys log server. I have done all the configurations to log all my messages to the server but it isnot logging anything ? The...
hello ,
I wanna store the logs as the Cisco device turn on i-e the boot process logs to any tftp server. as these logs are generated before the enable mode of a device, is there any way to do that ?
I get start getting this error on trying to reset my enable password on Cisco 2900 router .. I remove my flash to goto romon and when I reset my 0x2142 register the router boots to romon and i get the above error
1) To the main cisco sw end users, tp link routers, Dlink switches are connected2)I want the reachability b/w the server and the users not b/w the user and the user.3)I have DHCP configured. from ISP i provide a link to TP link Router which is acting...
I have installed this new switch a week before replacing a 3 tp link switches.The file server and my accounts server(that are mainly used) will be connected at the GB rest 2 servers will be connected to the 100mbps