I was playing around in Prime trying to add a device to the topology from the toolbar > Create > Create Device. It ended up adding 4 of them somehow off to the side. When I try to delete them by clicking them all I get is a small white box with not...
Last year I upgraded from 4.1.3 to CUCM 8.5 and it seems like over the past year I have been losing my ATA 188 devices. They worked fine after the upgrade but as time progressed they are no longer able to register. I know there is not a load for th...
I can't figure out how to do this. The Unity Connection 8.x article mentions:Caller input settings define actions that Cisco Unity Connection takes in response to phone keys pressed by callers during a call handler greeting. By using the settings ...
I have a user that has no data when I run a CDR department report. I noticed they did not have an owner user id associated. So I went into CCM and associated the user. However, there is no data when I run the report again. Will I be able to get t...
I'm looking at doing this upgrade in about a month and was wondering what my best option was. Current setup:CCM 4.1.3 in pub/sub on MCS 7835stwo 3745 h323 gateways~500 devicesNew hardware in test setup:CUCM 8 on the IBM appliance 2gb ram in pub/subp...
Hello Martin,I had ordered the 7.1.5 media and created a 7.1.5 cluster on the IBM appliances, I did not use VMware. I then used the DMA to restore the data from my 4.1.3 cluster onto the new 7.1.5 cluster then upgraded to 8.5. Hope this answers you...
This worked well. The total upgrade ended up taking quite a while. The DMA and migration to 7.5.1 was pretty much flawless. 7.5.1 > 8.5.1 however took a long time. For those of you making the migration soon. Just have patience. I was staring at...
