Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Team,I saw few past posts on this, but couldn't find an exact match. So, I am posting here again. Appreciate any feedback on this.Issue: Observed 'unknown protocol drops' on WAN interface connecting to AT&T WAN Circuit. Also, this counter increases a...
On Cisco ASR 1001-HX, we have a 10G-LR (on Te0/1/0) and 2x10G-SR (on Te0/1/2 and Te0/1/4) on BUILT-IN-8X10G/1G module.While 10G-LR works fine, but 2x10G-SR are not detecting on 'sh inventory'. Getting below error on 'sh logs'.*Aug 10 02:12:05.665 UTC...
Hello frnds,Just a quick quest:Can we configure stack with WS-C3750-24PS-S and WS-C3750V2-24PS-S. I mean.. with 3750 to a 3750v2.If yes, any specifc configs needs to be done on existing switch (now running with 3570)? or it will be same as 3750 to 3...
Hi frnds, have one doubt..Wht will be the cost of ckt having bandwidth 1 GB.I reffered some docs.. bit confused. as it is 1 for 100 MB ckts as per the formula 10^8/bandwith.pls suggest.Thanks.
Hi Friends,I have a 3825 router having HWIC-8A async card, and want to cnfigure that for terminal server connectivity. I believe it will have different config to NM-16A module config. any advice please.Thanks..Arun
Thanks for the input. Here I check the PE side interface config. Is there anything else I should look at?PE#sh run int TenGigE0/5/0/0.121interface TenGigE0/5/0/0.121descriptionbandwidth 400000service-policy input V6_Ex_400M_70:15M:30M:40M:10:5M_in_su...
Thanks Marvin. Didn't notice this earlier. Seems this license "interface_10g (ASR_1000_HX_10GE_2P):" came by default. We have the ASR_1000_AdvEnterprise license in EOL. How to change it to use all 8 port? or is this license mandatory to run this rout...
