Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, ive got a question for you,Ive attached a picture of a job i look after. The other day the link failed, one end of one link died and the port channel didn't swap over to the backup link. I had to get someone on site to unplug port 38 on swit...
Hello community im having an issue with port forwarding i have a local device at SITE1 local lan 10.0.0.30 9100 im forwarding to dialer1 global port 9100 which is working, i can see the port alive when i scan the wan ip address with a port scanner.ip...
hello i was wondering if anyone can tell me an easy way to reset a LWAPP 1231G-A-K9 back to a stand alone unit? i have three an they are light weight, i was hoping to change them back?
Thanks for the reply, I will have another go at it. I've reset a few 890 routers but this unit is being difficult. I was just going to put it in the bin.
Hi, ive got the same issue. i can get into rommon but the c1111-8p doesn't want to accept any confreg registers i try. when i reboot it ither boots normally or loops back into rommon, is there a particular register in need to use for the c1111? i ca...
